Delta 28-185 Specifiche

(Model 28-185)DATED _23-95 PART NO _346498

BLADE TENSIONBlades of 1/8" 1/4 and 3/8 wide by 56-1/8" n length arewidths in order to provide proper blade tracking, cuttingperformance and

Fig__PADJUSTING UPPER BLADE GUIDESiMPORTANT: BOTH THE UPPER AND LOWER BLADE GUIDES MUST BE PROPERLYADJUSTED TO PREVENT THE BLADE FROM TWISTING DURING

ADJUSTING LOWERBLADE GUIDES ANDGUIDE BRACKET1. DISCONNECT THE MACHINE FROM THE POWERSOURCE.(FOR 1/4" AND 3/8" WiDE BLADES ONLY)2. Loosen the

TiLTiNG THE TABLETo tilt the table for angle sawing, loosen table tilting lockhandle (A) Fig. 26, and tilt the table until the pointer (B)indicates th

Fig.30DUST CHUTEA dust chute (A) Fig, 30, is supplied with your bench bandsaw and is equipped with a 1-1/2" I.D. opening that caneasily be connec

PORTER-CABLE • DELTA SERVICE CENTERS(CENTROS DE SERVICIO DE PORTER-CABLE o DELTA)Parts and Repair Servicefor Porter-Cable• DeltaMachineryareAvailablea

TABLE OF CONTENTSSAFETY RULES ...

SAFETY RULESWoodworking can be dangerous ifsafe and proper operating procedures are not followed. As with all machinery, there are certainhazards invo

ADDiTiONAL SAFETY RULESFOR BAND SAWS1, WARNING: Do not operate your band saw until itis completely assembled and installed according to theinstruction

A - BandSawwLh56q/8BladeB- TableC - Tablealigningscrew_washer,anaWingnutD ° Miter GageE _ _2) Adjusting Wrenches - 3ram and4ramF _ Table locking handl

[. _L._: >&'_,bl - !.qble ,ock,qq h,;lndie (b F'g 6 c _' stud._,d rup,_,ue bcu;w ',D} and _.prfng NOTE: Har]d_e iF) is_,p-&

FASTENING BAND SAWTO SUPPORTING SURFACEifduring operation there is any tendency for the machine totip over, slide, or walk on the supporting surface,

GROUNDING iNSTRUCTiONSCAUTION: THiS TOOL MUST BE GROUNDED WHILE iN USE TO PROTECT THE OPERATORFROM ELECTRIC SHOCK.In the event of a malfunction or bre

OPERATING CONTROLS AND ADJUSTMENTSSTARTING ANDSTOPPING SAWThe switch (A) Fig. 13, is locatedon the front side of thebandsaw. To turn the saw"ON&q