Delta DP115 Manuale delle Istruzioni

INSTRUCTION MANUAL8" Drill Press(Model DP115)PART NO. 906580 - 07-01-02Copyright © 2002 Delta MachineryESPAÑOL: PÁGINA 17To learn more about DELT

10TABLE ADJUSTMENTS1. The table can be raised or lowered on the drill presscolumn by loosening the table clamp handle (A) Fig. 17.Move the table to th

11SPINDLE SPEEDSFive spindle speeds of 620, 1100, 1720, 2340 and 3100RPM are available with your drill press. Fig. 21, illustrateswhich step of the mo

12ADJUSTING SPINDLERETURN SPRINGThe spindle is automatically returned to its upper mostposition when the handle is released. It is recommendedthat the

13CORRECT DRILLING SPEEDSFactors which determine the best speed to use are: kind of material being worked, size of hole, type of drill or othercutter,

14Two Year Limited WarrantyDelta will repair or replace, at its expense and at its option, any Delta machine, machine part, or machine accessory which

15NOTES

16NOTES

2GENERAL SAFETY RULESWoodworking can be dangerous if safe and proper operating procedures are not followed. As with all machinery, thereare certain ha

ADDITIONAL SAFETY RULES FORDRILL PRESSES3SAVE THESE INSTRUCTIONS.Refer to them oftenand use them to instruct others.1. DO NOT OPERATE THIS TOOL UNTIL

4Fig. A Fig. BGROUNDED OUTLET BOXCURRENTCARRYINGPRONGSGROUNDING BLADEIS LONGEST OF THE 3 BLADESGROUNDED OUTLET BOXGROUNDINGMEANSADAPTER2. Grounded, co

Use proper extension cords. Make sure your extension cord is in good condition and is a 3-wire extension cord whichhas a 3-prong grounding type plug a

6DRILL PRESS PARTSFig. 2Fig. 31 - Drill Press Head and Motor2 - Column and Base Flange3 - Base4 - Table5 - Chuck6 - Chuck key7 - Clamp handle8 - Wrenc

7ASSEMBLYWARNING: FOR YOUR OWN SAFETY, DO NOT CONNECT THE DRILL PRESS TO THE POWER SOURCEUNTIL THE MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UN

Fig. 1085. Thread the three pinion shaft handles (H) Fig. 8, intothe three holes located in the pinion shaft (J) as shown.Fig. 8JHHFig. 9KLM6. IMPORTA

9Fig. 14AFASTENING DRILL PRESSTO SUPPORTING SURFACEIf during operation there is any tendency for the machineto tip over, slide or walk on the supporti