Delta 11-950 Manuale delle Istruzioni

INSTRUCTION MANUAL8" Bench Drill Press(Model 11-950)PART NO. 900591 (011)Copyright © 2001 Delta MachineryESPAÑOL: PÁGINA 15To learn more about DE

10Fig. 18Fig. 19Fig. 20Fig. 21LOCKING SWITCH INTHE “OFF” POSITIONWhen the tool is not in use, the switch should be lockedin the “OFF” position to prev

11Fig. 22The spindle is automatically returned to its upper mostposition upon release of the handle. It is recommendedthat the handle be allowed to sl

12Fig. 25Fig. 26DRILLING HOLESTO DEPTHWhere a number of holes are to be drilled to exactly thesame depth, the stop nuts on the threaded stop rod areus

13CORRECT DRILLING SPEEDSFactors which determine the best speed to use in any drill press operations are: material, size of hole, type of drill orothe

14Delta Building Trades and Home Shop MachineryTwo Year Limited WarrantyDelta will repair or replace, at its expense and at its option, any Delta mach

2SAFETY RULESWoodworking can be dangerous if safe and proper operating procedures are not followed. As with all machinery, thereare certain hazards in

31. DO NOT operate your drill press until it iscompletely assembled and installed according to theinstructions.2. IF YOU ARE NOT thoroughly familiar w

4UNPACKINGYour drill press is shipped complete in one container. Carefully unpack the drill press and all looseitems from the container. Figure 2 illu

5CLEANINGRemove the protective coating from the machined surfaces of the drill press and all loose items.This coating may be removed with a soft cloth

6Fig. 6Fig. 7Fig. 8Fig. 94. Place the drill press head (F) Fig. 6, onto the column(A) as far as it will go. Align head to table and base andtighten th

7Fig. 10FASTENING DRILL PRESSTO SUPPORTING SURFACEIf during operation there is any tendency for the drill press to tip over, slide or walk on the supp

8MOTOR SPECIFICATIONSYour drill press is wired for 110-120 volt, 60 HZ alternating current. Before connecting the machine to the power source,make sur

9Fig. 14Fig. 17CHANGING SPEEDS AND ADJUSTING BELT TENSIONFig. 16SPINDLE SPEEDSFive spindle speeds of 620, 1100, 1720, 2340 and 3100RPM are available w