Delta DBN125 Manuale Utente

To learn more about DELTA MACHINERY visit our website at: www.deltamachinery.com.For Parts, Service, Warranty or other Assistance,please call1-800-223

10The depth to which a fastener is driven is controlled by the depth adjustmentknob (A) Fig. 25. The depth of drive is factory adjusted to a nominal s

11CLEARING A JAMMED FASTENERDisconnect tool from air supply.1. Open magazine and remove remaining fasteners (Fig. 28 and Fig. 29).Remove fasteners fro

12CLEAN AND INSPECT DAILYDisconnect tool from air supply before cleaning andinspection. Correct all problems before placing the tool back in use.Wipe

13TROUBLESHOOTINGDisconnect tool from air supply before performing any Service Procedure.SYMPTOM PROBLEMS SOLUTIONS1. Air leak near top of Loose scre

14A complete line of accessories is available from your Porter-Cable • DeltaSupplier, Porter-Cable • Delta Factory Service Centers, and Delta Authoriz

The following are trademarks of PORTER-CABLE •DELTA (Las siguientes son marcas registradas de PORTER-CABLE •DELTA S.A.) (Lesmarques suivantes sont des

2Date of Manufacture:___________________________Fecha de fabricación:, Date de fabrication:Serial No:______________________________________Número de s

3indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.indicates a potentially hazardous situation

4Fig. 6Fig. 5Fig. 2Fig. 3Fig. 41. Read and understand tool labels andmanual. Failure to follow warnings couldresult in DEATH or SERIOUS INJURY. Fig. 1

59. Do not connect tool to pressure whichpotentially exceeds 200 PSI (13.7 BAR).10. All air line components (hoses,connectors, filters, regulators, et

621. Remove finger from trigger when notdriving fasteners. Never carry tool with fingeron trigger. In “Contact Actuation Mode” toolwill fire a fastene

7Employer must enforce compliance with the safety warnings and all otherinstructions contained in this manual.Keep this manual available for use by al

8Fig. 19Fig. 18Fig. 21Fig. 23AFig. 22AFig. 20PREPARING THE TOOL1. After reading and understanding this entire manual, connect tool toair supply (Fig.

9USING THE TOOL Complete all steps of PREPARING THE TOOL before using the tool.This tool is shipped from the factory with a “single sequential actuati