Delta RMC101 Manuale Utente Scaricare il pdf (Pagina 9)

RMC100 Startup Getting Started

deltamotion.com

Command area — The six registers in this area are used to send commands to the

RMC100 controller.

Parameter area — The sixteen registers in this area are the operational parameters.

This area contains information on scaling, tuning, and configuration for fault

detection.

Plot Time — Specifies plot duration, or length of data log, in seconds.

Toolbar — Tools in the toolbar include:

Opens a new board file.

Opens an existing board file.

Saves the current board file.

Sends parameters listed in the Parameter area of the display to the RMC100

controller and initializes the axis.

Halts a selected axis (ramps the axis to a stop).

Kills all axes (sets the drive outputs to 0 Volts).

Saves controller information to non-volatile memory.

Retrieves a plot of the selected axis from the RMC100 controller.

These buttons are pre-programmed commands that you can execute by clicking on

the appropriate number. Instead of entering values in the COMMAND area of the

display you can pre-program commands into each button, then by clicking a button

or pressing a shortcut key, quickly execute the pre-programmed command.

Status Bar — Indicates the state of the serial communications to the RMC100,

Read or Write mode, and CAPS LOCK.

Starting the RMC100 Controller

1. Connect power to the RMC100 controller.

Note: The RMC100 controller requires 24 VDC at various current levels up to 750

mA, depending on the communication and transducer interface modules used.

2. Connect the PC to the RMC100 controller using one of the following two

methods.

• Connect a standard null-modem DB-9 RS-232 serial cable from the PC to

the RMC100 controller.

− If the serial port is configured correctly, the Offline message in the

lower right corner of the RMCWin status bar will change to Online

and a pop-up message window will indicate that RMCWin can

communicate with the RMC100 controller.

− If the display indicates Offline and an RMC100 controller is connected

and has power, try changing the serial port by double-clicking on

COM in the lower right corner of the RMCWin status bar. The

Index/stored

commands/Editing the Stored

Command Table

Contents/Using

RMCWin/Setup Options/Selecting

a Serial Port to Use

Contents/Communication

Types/RS-232/Wiring.

Index/specification/general/

power

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 67 68

Commenti su questo manuale

Nessun commento

Delta RMC101 Manuale Utente Pagina 9

Commenti su questo manuale

Prodotti e manuali riguardandi Sensori Delta RMC101