Delta MMC120 Manuale Utente Scaricare il pdf (Pagina 135)

135

Link Value: Bit pattern that must be set or cleared

Range: Any bits

These link types wait for at least one of a user-selectable group of Status Bits to be set or

cleared on the current axis.

Using with the

Link Type and Link Value

Popup Dialog

1. Under Link Type Category, select Current Axis (Basic).

2. Under Link Type, select Status Bits.

3. Under Link Condition, select the appropriate option for whether you wish to wait

for one or more bits to be ON or OFF.

4. Under Link Condition, select the check boxes next to the Status bits that you wish

to monitor with this link type.

Using without the

Link Type and Link Value

Popup Dialog

1. Select the Link Type:

Use‘B’ifyouwishtowaitforStatusBit(s)tobeon,‘b’ifyouwishtowaitfor

Status Bit(s) to be off.

2. Enter the Link Value. Use the STATUS Word Bit Map to calculate a 16-bit

hexadecimal word that matches the bits you wish to wait for.

Selected Axis Link Types

Link Type - Any Axis Position

Link Type: See below

Link Value: Limit Position

Range: Any valid position in Position Units

These link types are used to detect when the position of the axis selected by the link type

is above or below a limit. This link type can be used to change speeds on-the-fly or

trigger events on another axis. The Link Value holds the Limit position in position units.

Either the Target Position or Actual Position may be used to compare with the Limit

position.

Using with the

Link Type and Link Value

Popup Dialog

1. Under Link Type Category, select Selected Axis (Enhanced).

2. Under Axis, select the axis you desire to monitor.

3. Under Link Type, select Position.

4. Under Link Condition, select whether you wish to use Target or Actual Position

for the comparison.

1 2 ... 130 131 132 133 134 135 136 137 138 139 140 ... 149 150

Nessun commento

Delta MMC120 Manuale Utente Pagina 135