Delta MM300 Manuale delle Istruzioni Scaricare il pdf (Pagina 12)

OPERATING CONTROLS AND ADJUSTMENTS

ON-OFF SWITCH

The switch (A) Fig. 26, is located on the side of the

motor. To turn the machine “ON”, move the switch (A),

up to the “ON” position. To turn the machine “OFF”,

move the switch down to the “OFF” position.

Fig. 26

LOCKING SWITCH IN

THE “OFF” POSITION

When the tool is not in use, the switch should be locked

in the “OFF” position to prevent unauthorized use. This

can be done by grasping the switch toggle (B) Fig. 27,

and pulling it out of the switch, as shown. With the

switch toggle (B) removed, the switch will not operate.

However, should the switch toggle be removed while the

machine is running, the switch can be turned “OFF”

once, but cannot be restarted without inserting the

switch toggle (B).

Fig. 27

Fig. 28

RAISING AND

LOWERING THE HEAD

The head (A) Fig. 28, is raised and lowered by means of

the lever (B). For maximum leverage during the mortising

operation, the lever (B) can be repositioned by pulling

out the hub (C) of the lever assembly and repositioning

hub on the pinion shaft.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18

Nessun commento

Delta MM300 Manuale delle Istruzioni Pagina 12