Delta 902118 43-505 Manuale delle Istruzioni

INSTRUCTION MANUALRouter / Shaper(Model 43-505)PART NO. 902118 (0112)Copyright © 2001 Delta MachineryESPAÑOL: PÁGINA 19To learn more about DELTA MACHI

10SEE-THRU CUTTER GUARDThe see-through cutter guard (A) Fig. 20, should alwaysbe used when using the fence to guide the work. Theguard (A) raises as t

115. Loosen adjustment bolt (D) Fig. 24, and correspondingbolt at the rear of the machine (not shown.).6. Carefully move the spindle height lock knob

12INSTALLING ROUTER BITS1. DISCONNECT MACHINE FROM POWER SOURCE.2. Raise spindle to the maximum height and tightenlock knob.3. This machine is supplie

13INSTALLING OVERHEADCUTTER GUARDAn overhead cutter guard, shown in Fig. 31, is suppliedas standard equipment with your Router/Shaper andshould always

14OPERATIONThe following is an example of the setting-up and operational procedures when using the fence, collars andstarting pin. Please review this

15POSITION OF COLLARS1. The collars may be used in any of the following po-sitions: above, below or between two cutters.2. When the collar is used bel

Two Year Limited WarrantyDelta will repair or replace, at its expense and at its option, any Delta machine, machine part, or machine accessory whichin

17NOTES

18NOTES

2GENERAL SAFETY RULESWoodworking can be dangerous if safe and proper operating procedures are not followed. As with all machinery, thereare certain ha

3ADDITIONAL SAFETY RULES FORFOR THE ROUTER/SHAPERWARNING: FAILURE TO FOLLOW THESE RULES MAY RESULT IN SERIOUS PERSONAL INJURYFig. B21. USE A HEAVY WOR

4POWER CONNECTIONSA separate electrical circuit should be used for your machines. This circuit should not be less than #12 wire and shouldbe protected

Use proper extension cords. Make sure your extension cord is in good condition and is a 3-wire extension cord whichhas a 3-prong grounding type plug a

6ASSEMBLYASSEMBLINGACCESSORY STANDIf you purchased the accessory stand for use with yourRouter/Shaper, the stand must be assembled as follows:1. Remov

7ASSEMBLING OVERHEADCUTTER GUARD BRACKETAssemble the overhead cutter guard holding bracket (A)Fig. 6, to the rear of the Router/Shaper and fasten with

86. Place dust hood (P) Figs. 9 and 10, over dust chute(H) and fasten dust hood to back of fence body (A) usingtwo M5x10mm sheet metal screws (S), as

9OVERLOAD PROTECTIONThe Router/Shaper is equipped with overload protection.If the motor shuts off, or fails to start due to overloading(cutting stock