Delta 11-990 Manuale delle Istruzioni Pagina 1

INSTRUCTION MANUAL12" Bench Drill Press(Model 11-990)PART NO. 903709 (018)Copyright © 2001 Delta MachineryESPAÑOL: PÁGINA 17To learn more about D

1013. IMPORTANT: Make certain the spindle taper (Q) Fig.17, and tapered hole in chuck (R) are clean and free ofany grease, lacquer or rust preventive

11STARTING AND STOPPINGDRILL PRESSThe switch (A) Fig. 21, is located on the front of the drillpress head. To turn the drill press “ON” move the switch

123. The table can be tilted right or left by pulling out andremoving table alignment pin (C) Fig. 25, and looseningtable locking bolt (D). NOTE: If p

13Fig. 30CB5. After the belt is positioned on the desired steps ofthe motor and spindle pulleys, pivot motor away from thedrill press head until the b

14OPERATIONThe following directions will give the inexperiencedoperator a start on common drill press operations. Usescrap material for practice to ge

15Two Year Limited WarrantyDelta will repair or replace, at its expense and at its option, any Delta machine, machine part, or machine accessory which

2GENERAL SAFETY RULESWoodworking can be dangerous if safe and proper operating procedures are not followed. As with all machinery, thereare certain ha

3ADDITIONAL SAFETY RULES FORFOR DRILL PRESSES1. DO NOT operate your tool until it is completelyassembled and installed according to the instructions.2

4POWER CONNECTIONSA separate electrical circuit should be used for your tools. This circuit should not be less than #12 wire and should beprotected wi

Use proper extension cords. Make sure your extension cord is in good condition and is a 3-wire extension cordwhich has a 3-prong grounding type plug a

6WARNING: FOR YOUR OWN SAFETY, DO NOT CONNECT THE TOOL TO THE POWER SOURCE UNTIL THEMACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE EN

7ASSEMBLY1. Assemble the column (A) Fig. 3, to the base (B) usingthe four M8x25mm hex head screws (C), three of whichare shown. Loosen set screw (D) a

84. Slide raising rack (F) Fig. 7, table and table bracketonto drill press column, as shown. Make sure bottom ofraising rack (F) Fig. 8, is engaged wi

99. Figure 13, illustrates the table raising and loweringhandle (K) assembled to worm gear shaft (G).10. Thread clamp handle (M) Fig. 14, into hole in