Delta 33-891 Manuale Utente Scaricare il pdf (Pagina 10)

Fig. 16

Fig. 17

Fig. 18

ADJUSTING TABLE

BRACKETS PARALLEL

TO TRACK ARM

To perform accurate work, the track arm must be parallel

to the table top brackets at both the front and rear of the

machine. To check if the alignment is correct, proceed as

follows:

1. Loosen yoke clamp locking lever (A) Fig. 16, pull up

yoke clamp index knob (B) and rotate yoke (C) to the out

rip position shown in Fig. 17. Tighten yoke clamp locking

lever (A).

2. Place wrench (D) Fig. 18, on flats of arbor and loosen

arbor nut (E) using wrench (F).

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

Nessun commento

Delta 33-891 Manuale Utente Pagina 10